Hi,"We are trying to setup NAT on a Cisco 3620 to work with our cable modem. Currently Ping works by both canonical names and IP address. However if we try to use HTTP the request times out. Using Wireshark it appears that all the HTTP requests ...
I have a cisco 3620. I just attempted to copy mySim flash image to a new 20 MB PMCIA flashRouter#show versionCisco Internetwork Operating System SoftwareIOS (tm) 3600 Software (C3620-IS-M), Version 12.1(3a)T7, RELEASE SOFTWARE (fc1)TAC Support: http...
HI,First question: is the 3600 series the newest EOL cicsco routesr or are their newer older models available(if that makes sense)?In any case, if the 3600 series are the newest EOL routers you can pick up used I am looking for some suggestions.I ha...
Hi.What memory expansion options does the Cisco 2650 have? I am not asking about dram, eprom, simm, or nvram. Is there any other way way besides the AIm Slot? Is there a pmcia option? In any case, is the AIM CF flash a place where a second boot ...
Hi,[We captured the traffic with a Mac Book Pro directly connected to the router. We conducted a ping sweep in two configurations: Our understanding is that the MBP offloads TCP Checksums to the network interface so that is why WireShark is flagging...
Hi,Sorry about the delay in responding as I still am struggling with this issue. The notification of a response to this thread ended up in my spam folder.In any case, ICMP seems to be moving along ok, but tcip seems squeezed. I did a little housekeep...
Ok, I will try it from the reformat side/recopy first. This was supposedly a new card but you never know. Is there any chance that the simm image will expand slightly diferently in flash memory then Simm? The size in bytes is the same on both cards....
Hi,I have it but i don't know if it is ok to pass it to you in this forum. Cisco restricts IOS downloads so why don'y you flag down a moderater and ask them if it within forum guideleines. If it is i have no problems with it.
hi,The 2960 xm is probably why I bought a 2600 in the first place. I didn't run into the finer priint about the boot lelper image untl later. The only problem with those two models is that they switched away form 5 volt simms in those models.Thanks ...
