About shyamradhe

shyamradhe · 10-03-2022

Hello EXperts,We have issue at one of our Cutomer Router (C1111-4p) , where we have Set Tunel 0 with Ipsec , with VTI tunnel on remote side, Suddenly tunnel is down(was working eralier) , reachability is fine form both end , no ACL in path . We can n...

shyamradhe · 04-10-2022

Hello Experts , now a days I am facing issue like customer is complaining for low internet speed,We noticed that Link is 100 Mbps but they are getting very low as 3 Mb download 1Mb upload , while their is no utilization over link , only 2-3 users are...

shyamradhe · 01-28-2019

I have a situation in which we have EIGRP network between 5 routers in same AS like ,A-B-C-D-E, Router E has default route towards ISP1 which has been redistributed in EIGRP and advertised to all other routers D,C,B and A,Now the new condition is tha...

shyamradhe · 06-04-2018

Hello All I am facing one issue today, I have 4 switch stack(2960x). 4 ports of switch have some issue( Gi 4/0/19 to 4/0/22) Issue is like below. When login, and check the status of these ports . it shows UP. But physical LED of that port is down and...

shyamradhe · 02-08-2018

Hello Experts, I am facing an issue with my Chassis Type : WS-C4507R+E, that any POE device is not getting up on Line card WS-X4748-RJ45V+E installed at slot 5, whereas same poe device is working on slot 6 line card.with same module.. !!!! ?? some...

shyamradhe · 10-06-2022

Hey MHM,Tried , Given Workaround on given bug ,( Reload & Increasing CAC limit) but no Luck !!!However We tried to Remove and Recreate the Pre-Shared key , and it resolved the issue !Not sure how it worked but finally issue is resolved for me .. tha...

shyamradhe · 10-04-2022

unfortunately i can't do this , due to limited access of customer HUB end router ..

shyamradhe · 10-04-2022

Not possible !!

shyamradhe · 10-04-2022

Yes Other side is also using same PFS group 16 ,Version - Cisco IOS XE Software, Version 16.09.05c1100-universalk9_ias.16.09.05.SPA.bin

shyamradhe · 10-04-2022

Thanks , I have tried to renew the certificate , but still having same issue.

Member Since	‎05-02-2016 10:50 PM
Date Last Visited	‎11-03-2023 05:35 AM
Posts	66

User Statistics

User Activity

Crypto Ikev2 stuck In-Neg state ,Maximum number of retransmissions

Very LOW speed While connected through Vedge

Dual eigrp route redistribution within same AS

Switch Port not working Cisco 2960x series

POE not working on WS-X4748-RJ45V+E for Chassis Type : WS-C4507R+E

Re: Crypto Ikev2 stuck In-Neg state ,Maximum number of retransmissions

Re: Crypto Ikev2 stuck In-Neg state ,Maximum number of retransmissions

Re: Crypto Ikev2 stuck In-Neg state ,Maximum number of retransmissions

Re: Crypto Ikev2 stuck In-Neg state ,Maximum number of retransmissions

Re: Crypto Ikev2 stuck In-Neg state ,Maximum number of retransmissions