I purchased VIRL but the ASAv appliance doesn't have any .pkg files loaded for Anyconnect. I do have the ability to download the files directly from Cisco but I want to make sure I'm not going to run into a license issue. Does VIRL or the ASAv give m...
Does Cisco have a published document that shows the requirements for their SCRYPT implementation (type 9 encryption)? I want to be able to generate all of my secrets off the device and them import them later but I need to know the values they use for...
I have two N9Ks connected to each other with OSPF running between them using unnumbered loopbacks. If I go to either switch and do a show ip route x.x.x.x (to it's peer) I get two possible candidate routes. Everything works fine and I can ping my ne...
This is an ASA 5506X running 9.8(3). I need to change the IPv6 DUID to accommodate a prefix-delegation problem with my provider and, unfortunately, I cannot find any DUID related commands. Google doesn't turn up anything helpful either. Does anyone k...
@Diana Karolina Rojas wrote:
Please read the last reply from this post https://supportforums.cisco.com/t5/lan-switching-and-routing/access-list-wrong-order/td-p/3070419
Do not forget to rate useful answers.
I have this same problem and I've tested it on two versions; IOS-15.6.2 and XE-16.07.
If I enter this:
ip access-list standard TEST
I end up with this
Standard IP access list TEST 30 per...
There is an obscure MIB called AIRESPACE.MIB which contains the correct OID for it under 188.8.131.52.4.1.14184.108.40.206.1.6. The Cisco download for this MIB comes up as invalid in all of my parsers but searching it does produce the correct OIDs
The problem was due to an interoperability issue between ESXi and the HP G8 blades. Both Cisco and VMWare have identified an issue where the packets are corrupted once trunking is enabled. VMWare is working with HP to resolve the issue.