About YagBaca95622

YagBaca95622 · 06-01-2020

Hi Experts,We are facing some issue on what I think is caused by fragmentation.After doing a packet capture on the network, we noticed that we are receiving multiple Dup ACKs, Re-transmissions and TLS Ignored Unknown Record。Multiple applications are ...

YagBaca95622 · 05-14-2020

No Answers, PLEASE DELETE

YagBaca95622 · 04-27-2020

Hi Collaboration Community,I have very minimal knowledge on the collaboration field so please kindly help me on this one.(Our Voice team has been t-shooting this for over 2 months know and now got me involved)We have the following set-up:Site A (Cisc...

YagBaca95622 · 02-06-2020

Hi,Is it possible to see the FEX uplink port via the CLI? (No physical access to the device, For documentation purposes).For example, we have an Nexus 5 or 7K configured to support the N2k.How can we know the physical port which is connected to the N...

YagBaca95622 · 05-06-2020

Hi @Ayodeji Okanlawon, Experts,Thank you for the analysis.Just to make sure that I got it right. (Please correct me if I'm wrong)1. Site A (Cisco DX70) initiates the call to Site B(Cisco TelePresence MX300 G2)DX70 sends Message Type: Setup to the Exp...

YagBaca95622 · 05-01-2020

Hi,Thank you for the support.That is the very first thing that I did after they passed the problem to me.There are no FWs in the path, just a few ACLs without deny statements and an IP ANY ANY at the end.Anything else, what I might have missed?

YagBaca95622 · 05-01-2020

I'm sorry for the delayed response.They just gave me permission to access the devices a few moments ago.Call details:Start: 2020-05-01T17:10:11.373+09:00Caller: Site A (Cisco DX70)Receiver: Site B(Cisco TelePresence MX300 G2).IP's are provided right ...

YagBaca95622 · 02-17-2020

Apparently, no one knows the actual physical layout.We are trying to document the network from scratch.Is it possible for this specific switch to exceed the allotted number of uplink ports?N5K-C5624QI also tried to check if this might be a bug but it...

YagBaca95622 · 02-16-2020

Hi Mark,Looks like that's the command we are looking for but one more question cam up. On the N2k-2348TQ there are only 6ports for the uplink:https://www.cisco.com/c/dam/assets/prod/switches/nexus-2000-series/nexus-2348tq-10ge-fabric-extender-3d-mode...

Member Since	‎11-19-2019 04:45 PM
Date Last Visited	‎09-02-2020 12:40 AM
Posts	10
Total Helpful Votes Received	5

User Statistics

User Activity

Policy Based L2L VPN MTU and MSS config

Phase 2 unable to complete due to some QM FSM error

Unable to call with Cisco Expressway (One-way)

Is it possible to know FEX UPLINK port via CLI?

Re: Unable to call with Cisco Expressway (One-way)

Re: Unable to call with Cisco Expressway (One-way)

Re: Unable to call with Cisco Expressway (One-way)

Re: Is it possible to know FEX UPLINK port via CLI?

Re: Is it possible to know FEX UPLINK port via CLI?