Have used the following IPs for reference :Jump Server IP: 192.168.10.5 (Subnet A - AWS)ASAv30 inside interface IP: 192.168.20.5 (subnet B - AWS) Able to ping the ASAv inside interface from the Jump Server, but unable to SSH/HTTPS the ASAv inside in...
We have a few ISR 4000 series routers which need to be monitored using SNMP by a third-party NMS server. The NMS monitors Interface status and Bandwidth utilization by default but requires MIBs to be uploaded for monitoring the other components and I...
Hardware: ASAv30Cisco Adaptive Security Appliance Software Version 9.9(2)1 Whenever I try to enter any show run command, for example "show run" or "show run access-list", the CLI terminal hangs up without generating any output and I have to close the...
VPN tunnel is set up between an ASAv30 on AWS and ASA5545-X on-premise. Recently, a new connection was added which is having issues, the flow is as follows:AWS Server (172.18.1.7) -> AWS ASAv30 -> ASA5545-X -> Physical Server (172.16.100.5) Following...
Need to allow remote peer to RDP my Server. We need not access their devices.Successfully established an IKEv1 VPN tunnel between two ASA. Private IP of Server is Translated to public IP and sent over the VPN tunnel. The remote user is able to ping m...
Generated new keys using the following command:crypto key generate rsa general-keys modulus 1024 Tried connecting again, but the same result. Logging buffered is enabled but did not receive any logs for source 192.168.10.5.However, the capture still ...
Hi @jimholla , This ASAv30 is deployed on the AWS using a "c4.xlarge" instance. I'd love to upgrade but since the show run commands are not working, I'm unable to take a backup of the device configuration.
Hi @vsurresh, The issue is resolved now. Since these servers were on a different subnet from the ASA subnet, a route had to be configured on the firewall to reach them.Thanks for your help. Thanks @Rob Ingram for pointing out that the packet drop cou...
The same interface is used. An additional interface wasn't configured for the new subnet. The ASA interface and new server are both in different subnets. I do not see the server IP 172.18.1.7 in the ASA's ARP table. I tried adding it manually but it ...
