About HunterMathews2967

HunterMathews2967 · 12-22-2019

First project out of school is to install new WIFI across the plant. The WAPs need to broadcast 2 SSIDs, one for Plant (static IPs) and one for Comcast (DHCP, handled by firewall). Plant SSID currently works and has full connectivity to plant network...

HunterMathews2967 · 12-11-2019

Network that I am trying to access is 199.8.0.0/16 and is on VLAN 1 AP01 joins WLC-1 and begins broadcasting SSID "CISCO2_test". Created a vlan 1 interface:Interface Name Port Vlan Id IP Address Type Ap Mgr Guest-------------------------------...

HunterMathews2967 · 12-09-2019

First time setting up a network with WLC. WLC is configured and can both web browse and SSH into it. It currently has 1 SSID configured. I hardwire one of the APs into port 3 (PoE port) and it doesn't receive the SSID configuration.WLC Firmware is 8...

HunterMathews2967 · 12-31-2019

but if it is problematic then the solution could be to connect on the plant switch to the firewall an access port in vlan 1, an access port in vlan 10, and an access port in vlan 99 and on the Comcast switch connect an access port in vlan 10 and an a...

HunterMathews2967 · 12-30-2019

WAP communicate on both networksAt the moment, the WAPs are plugged into VLAN 1/Plant network (but are trunked) and broadcasting the SSID fine. We want to be able to broadcast a 2nd SSID, while plugged into these trunk ports to broadcast VLAN 10/Comc...

HunterMathews2967 · 12-30-2019

Going to preface your questions with my goal for this project, then come back and answer the questions. I have a new wireless network that I would like to be able to broadcast 2 SSIDs, each SSID is tied to a different VLAN/Network. Network 1: Plant N...

HunterMathews2967 · 12-29-2019

- is it your intention that the new vlan 15 would use the existing DHCP scope from the firewall or would the new vlan have a new DHCP scope on the firewall?I would like for it to be the same DHCP scope - you tell us that you configured the switches i...

HunterMathews2967 · 12-29-2019

Its a checkpoint firewall. I quickly looked through the GUI and couldn't find a way to check to make sure the interface was set to trunk. When I get to work tomorrow, I'll try to GUI in to it.

Member Since	‎12-09-2019 10:16 AM
Date Last Visited	‎01-31-2020 05:33 AM
Posts	23

User Statistics

User Activity

Issues bridging networks via seperate VLANs

AP 1562E joins WLC 3504, SSID is broadcasted, assign static IP for the network, but cannot gain access to network

WLC 3504 Unable to see AP 1560

Re: Issues bridging networks via seperate VLANs

Re: Issues bridging networks via seperate VLANs

Re: Issues bridging networks via seperate VLANs

Re: Issues bridging networks via seperate VLANs

Re: Issues bridging networks via seperate VLANs