jafarsadiq
Beginner
Beginner
Member since ‎11-01-2005
‎08-18-2017

User Statistics

  • 12 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Hi Cisco Experts,Kindly need your advice on the below;Setup : Cisco ASA 5520Any Traffic from any source pointing to Destination IP (Ex: 192.168.10.10:53) to be NATed (Destination Translated) to 172.16.10.10:53. The ASA will have route to 172.16.10.0/...
Hi...We have a ACS Appliance integrated with MS AD and users are authenticated successfully. Our Requirement is that, we have 3 Departments with 20 Edge Switches each. I have created 3 Network Device Groups (NDG) for each department in ACS with 20 Sw...
Dear Security Experts,I am facing a issue in FWSM. I couldnt even get a clue why the nameif command is not working in Fwsm. All the required commands are done in CoreSwitch (Vlan group etc) and i can see the vlan also in fwsm.please gimme some hint t...
Dears,As we know in Routers, we create a local Username/password and configure the vty line with "privilege level 15" command and the user will go directly to priv mode.how can we do this in ASA/FWSM??? I have done AAA and also Local U&P, the users g...
Dear Experts,I have a setup, in which the LAN Users have to establish a IP-Sec VPN to a remote ASA with public IP. But, the Users have to cross 1 FWSM and 2 ASA's to reach the Internet and no access restrictions are done. I mean, IP ANY ANY... NAT'in...
Community Statistics
Member Since ‎11-01-2005 07:10 AM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 12
Helpful Votes Given To