About djagdale97

djagdale97 · 03-13-2022

Hi, I am getting below error when tried to configure ip flow monitor in management interface. Router(config-if)#ip flow monitor FLOW-MONITOR-IPV4 output% Flow Monitor: Failed to add monitor to interface: Management Interface Unsupported Please he...

djagdale97 · 01-06-2020

Hi,My organization is planning to upgrade nexus 3048 & 3172T NXOS from version 6.0(2)U6(10) to version 7.0(3)i7(7)can anyone help me how can i go ahead for this, can i directly upgrade version 6.0(2)U6(10) to 7.0(3)i7(7) or need to upgrade version 7....

djagdale97 · 12-20-2019

Hi,I have nexus 5596 switch in which interface state is shown inactive even if port is admin up. i want to know why port status is shown as inactive. below is the port configuration.show run interface Eth1/30!Command: show running-config interface Et...

djagdale97 · 03-13-2022

Hi pman,Received same below reply from TAC. Thanks.This is purely hardware limitation and is the architecture design of ASR1k device. Management interface is directly connected to RP. It has no connection with FP at all so Gig 0 cannot be used for n...

djagdale97 · 03-13-2022

Hi pman, Router model is cisco ASR1001-HX Regards,Dhiraj Jagdale

Member Since	‎12-20-2019 12:37 AM
Date Last Visited	‎03-13-2022 05:06 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Unable to add ip flow monitor in management interface

Need to upgrade nexus 3k NXOS

Need to know why interface status shown Inactive state in nexus 5596

Re: Unable to add ip flow monitor in management interface

Re: Unable to add ip flow monitor in management interface