About rochdalemis

rochdalemis · 12-14-2010

Hello,What debug commands I can use to see which dial peers match a phone number dialed and which dial peer is actually used to route a call? I also want to see which port the call is routed through.I plan to use csim start command from CLI to test ...

rochdalemis · 12-13-2010

Hello,Is there any way to use a button on a 7940 or a similar phone to forward all calls on a non-primary line on CME/UC-540?The CFwdAll button works fine for the primary line, but I would like to control the other lines assigned to buttons on my pho...

rochdalemis · 12-13-2010

Hello,I have 8 FXO POTS trunks and would like to assign preference on how they are used for outgoing calls.I have the following config:dial-peer voice 80 pots preference 7 destination-pattern [2-9]......$ port 0/1/0!dial-peer voice 81 pots preference...

rochdalemis · 12-10-2010

Hello, team!I have UC-540 and a setup that does not require users to dial "9" to place outgoing calls. This omission left me unsupported by Cisco, hence I ask you for help.I have 8 POTS ports and 8 corresponding dial peers with pattern set as "[2-9]...

rochdalemis · 12-14-2010

Ok, but is there a way to see what decisions IOS makes as it goes through a list of configured dial peers, preferences, hunting groups?I already posted a question here, but received back only what I already knew.Briefly, below is what I have. When a ...

rochdalemis · 12-14-2010

Javalenc, I have tried to use debug voice ccapi all and while it was providing info on called number and chosen dial peer, the call, actually, was going through another dial peer. So, perhaps, I was looking at a different level.I have an overlapping ...

rochdalemis · 12-13-2010

Paolo,AT&T in Kansas City. They at least expect me to omit "1" on local and regional calls. Otherwise users hear an error message recording. In NYC, I agree, you can get away with full 11-digit entry.I am thinking about playing with dial-peer priori...

rochdalemis · 12-13-2010

Java, the referenced article mentions problems when one of the ports in a group being non-operational. What is the expected behavior if a port in a group is in use or physically disconnected?Do port groups affect distribution of incoming calls in an...

rochdalemis · 12-13-2010

Rob, thanks. Will try it today.Is there any way to call into CUE and do the same via prompts?My users would like to be able to forward to their cell phones when they cannot make it to the office in time...Thank you!Greg

Member Since	‎12-10-2010 11:52 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	10

User Statistics

User Activity

Troubleshoot / debug dial-peer and call routing on CME / UC-540

CFwdAll non-primary line

Preference in dial-peer configuration

POTS and SIP dial peer collision

Re: Troubleshoot / debug dial-peer and call routing on CME / UC-

Re: Troubleshoot / debug dial-peer and call routing on CME / UC-

Re: POTS and SIP dial peer collision

Re: Preference in dial-peer configuration

Re: CFwdAll non-primary line