Hi All
I’m not sure if any of you have encountered such issues but my company recently purchased 2 units of Cisco Catalyst 4507RE that comes with quad Supervisor module 8L-E. We enabled VSS in our staging environment, and this is good.
However, I ...
Hi Peers
I have a 2 Cisco ASA Firewalls, each in separate sites i.e. Site1 and Site2 that is running site-to-site vpn. This is working fine. Both the LANs are able to ping each other.
Site1 LAN Network Address : 10.10.10.0/24
Site2 LAN Network Addre...
Sourcefire firesight rule update unable to install.
Error message:
Import failed: Invalid rule syntax found in file. Verify your rule syntax is correct and that your upload is an ASCII or UTF-8 encoded plain text file. View the rule update log for er...
Yes sir, I am fully aware that dual leg is always the best option. I agree with you. However, my question here is why in C4507RE+ the chassis has to reboot when active sup fails in vss mode, but you don't find such behavior with C6509E?
Hi Sir I disagree with your explanation because in C6509E, when the active Sup fails, nothing gets rebooted, and everything is seamless. It's only with C4507RE+ that the chassis reboots :-( Please kindly advice if I've misunderstood your explanation...
Thanks Reza. Please do correct me if I'm wrong but if that's the correct behavior, why on earth is Cisco selling VSS solution in C4507RE. I think it's just silly. I mean you don't get this silly behavior in C6509E chassis. When the active sup fails, ...
Hi,
With regards to my newly purchased Catalyst 4500E Supervisor Engine 8L-E : Catalyst 4507R+E Switch, the IOS XE version that I'm running on is 3.8.3E(ED).
I was told by Cisco TAC that even if I were to upgrade to the latest firmware, the product...
Hi SirThanks for your reply. Just to clarify, I'm using Cisco ASA 5520 v8.2. Hence, can I confirm the following solution;
ASA1 in Site1static (inside,outside) 20.20.20.50 10.10.10.150 netmask 255.255.255.255
ASA2 in Site2static (inside,outside) 10....
