About LuvAggarwal61728

LuvAggarwal61728 · 01-25-2020

hi, I am using 2 rv340 routers on my 2 wan sites. i have 2 networks connected via a site-to-site vpn. 192.168.0.0 and 192.168.6.0. I also have a l2tp vpn setup for remote users. network is 192.168.10.0 (this vpn is setup on the router for 192.168.0.0...

LuvAggarwal61728 · 01-13-2020

hi, I am using 2 rv340 routers on my 2 wan sites. i have 2 networks connected via a site-to-site vpn. 192.168.0.0 and 192.168.6.0. I also have a l2tp vpn setup for remote users. network is 192.168.10.0 (this vpn is setup on the router for 192.168.0.0...

LuvAggarwal61728 · 01-10-2020

Hi All, I have a scenario where i need a little help. it's like a Router on a stick config but with a firewall in the middle. I have a cisco switch, a sophos firewall and the rv340 router. i have setup 2 vlans on the switch and same vlans on the rv34...

LuvAggarwal61728 · 01-04-2020

I have a cisco router rv340. I was trying to troublehshoot issues with l2tp client remote access, So i enabled a setting in the router "log" page to allow me to see all the debugging information in the log. But after i did this and tried to login lat...

LuvAggarwal61728 · 02-01-2020

how to verify this? the routers knows to route the traffic from/to all 3 networks as they are part of the site-to-site vpn settings, so i don't think so but not 100% sure.

LuvAggarwal61728 · 01-29-2020

gap router is doing NAT for wan traffic in the local network (192.168.6.0). But i have 192.168.10.0 network added in the site-to-site vpn config.

LuvAggarwal61728 · 01-27-2020

Hi rick,on both routers, the firewall features are turn off. This is a small business router (rv340). 1. I have 192.168.10.0 network added as a static route on the gap router (192.168.6.11) and as part of the "ip address group" on both aap router and...

LuvAggarwal61728 · 01-27-2020

Yes aap router is also the l2tp server. i also have the address pool 192.168.10.0 added to the ip address group (i think this is specific to rv340 router) in the site-to-site vpn config.

LuvAggarwal61728 · 01-26-2020

below is the diagram for the network: 2 sites. AAP site (192.168.0.0) is where i have the router with the l2tp vpn setup. And the GAP site is the remote subnet. The users logging in from home are able to see all devices on aapsite but not on gap site...

Member Since	‎01-04-2020 12:19 PM
Date Last Visited	‎02-19-2020 10:17 AM
Posts	18

User Statistics

User Activity

need to have remote users access to site-to-site subnets

need to have remote users access to site-to-site subnets

question about a scenario i have

Router rv340 small business - unable to login after enabling debugging in logs

Re: need to have remote users access to site-to-site subnets

Re: need to have remote users access to site-to-site subnets

Re: need to have remote users access to site-to-site subnets

Re: need to have remote users access to site-to-site subnets

Re: need to have remote users access to site-to-site subnets