In an EVE-NG lab, I have connected a vedge directly to a 7200 router and configured both interfaces facing each other on the same subnet 10.10.10.0/24. the vedge needs to reach out of this network to reach the controllers in a different network, but ...
I've been looking into this as we're getting very close to the new Cisco exams and it seems to be accurate, but I can't be sure because I didn't find the official information to confirm it.. I want to complete both CCIE R&S Written and CCNP TSHOOT a...
I'm basically seeking advice from someone who might have followed or observed the progression and aging of Cisco's cert guides and the whole environment. I'm worried that since it's only the first edition of encor 350-401 (which is not cheap) that it...
I'm talking about a vedge not a cedge.. a vedge only takes interface and ip route config under vpn. under global config:vEdge(config)# ip route?^% Invalid input detected at '^' marker.
as mentioned, vbond is already reachable from this subnet internet#ping 192.168.11.13 source 10.10.10.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.11.13, timeout is 2 seconds:Packet sent with a source address of 10.10.10.1...
