phcjpp123

Fixed by attaching laptop directly +  a factory reset.TaChris

Hi Guys,I have 3 ap541n's in a cluster. I have upgraded 2 of them to 2.04 firmware. The third did no...

Thanks Jasbryan,If i may ask - was your answer a generic one (make sure you have the latest firmware...

Hi Guys,I am using around 5 sg300's with a lot of Crestron AV kit / touchscreens. About once every c...

Sorry for not replying sooner. Here is the diagram. Sg300 and UC320W are pretty much factory setup. ...

Hi,I am now very used to the SG300 smartports features and use them happily with a UC320W and multip...

Got it - after 1hr with cisco support (who were awesome) we got it down to a IP/MAC binding setting ...

Still no further. I can now get it a DHCP address by specifying a dhcp helper address on the sg300 s...

Thanks Dave,I spent another fruitless day on this. In the end with a hard coded IP I found I could g...

I am having exactly this problem. WET200 into AP541 into SG300. DHCP from router connected to SG300....

Just checked and upgraded to 2.01 - i can now ping - lets hope it remembers it as in the past it has...

I believe so yes - AP541N-K9-2.0(0) CheersChris

Hi Guys,I have a setup involving 3 clustered AP541 running off a sg300 switch. The wireless network ...

Thanks guys - worked like a charm. The firmware upgrade and the reset to defaults fixed everything.C...

Hi,I am setting up a uc320w with 4 x 504g phones on a sg300 switch. I know there is an application n...