About David Garcia

David Garcia · 12-04-2013

Hi, I have setup a Site-to-Site VPN between an ASA and a cisco Router (UC520). The tunnel is up, but no traffic is coming through, although on the ASA I'm seeing the counters for TX and RX increasing. Troubleshooting I found that the router has only ...

David Garcia · 10-22-2012

We are deploying a new UC560 where a group of phones are going to be placed at a remote location. The phones register successfully with CME through a Site to Site tunnel made from 2 ASAs. At first we enabled as Teleworker all the phones in the remote...

David Garcia · 12-04-2013

UPDATE: I solved this issue. The router by default allowed any connections to the port UDP 500 used for setting up the tunnel. But then when the traffic needed to enter using IPSec that uses ESP (protocol 50) the router blocked that connection and no...

David Garcia · 12-04-2013

UPDATE: I just confirmed that the traffic is getting to a host in one side of the tunnel (behind ASA). I installed wireshark and I was able to capture the traffic comming from the the other network. But the reply is not getting to the router. See bel...

David Garcia · 10-23-2012

Well at first this will be our only site, but in the future we will be adding more remote sites. But I now understand.Thanks for your response.David

Member Since	‎10-03-2012 07:00 AM
Date Last Visited	‎10-09-2017 11:56 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Site-to-Site VPN Up but no traffic passing through

VPN Bandwidth usage between teleworkers extensions calls in the same remote site

Re: Site-to-Site VPN Up but no traffic passing through

Re: Site-to-Site VPN Up but no traffic passing through

Re: VPN Bandwidth usage between teleworkers extensions calls in