About mkmead

mkmead · 06-26-2020

When I remotely ping from a remote network 192.168.210.x to a server (192.168.17.x) it fails.1. I have already enabled "same-security-traffic permit inter-interface"2. I have already a policy map to do TCP state bypass the ASA logs show:4Jun 26 20201...

mkmead · 08-06-2014

I am working on setting up a new ACS 5.5. server and we are trying to move to having Active Directory be our authentication/Identity portion of our device management. I have noticed that the only choice under the "Access Policies/Access Services/Defa...

mkmead · 11-21-2011

Our current router is setup to redistribute our BGP routes into OSPF using the following code:router ospf 60 log-adjacency-changes redistribute bgp 65199 metric 1500 metric-type 1 subnetsI want to filter down the routes so only a set of specific rout...

mkmead · 09-06-2011

I have to setup a auto attendant (Call Handler) in unity connections.when I got to test the call handler and call it at the extension I setup I always here the following message before it plays the call handler prompts."Sorry,(blank) is not available...

mkmead · 10-16-2007

I currently have a problem where I have two routers setup on the same segment. One router is a in country Frame Relay network connection into it and the other is running a VPN encyrpted Tunnel over a public ADSL connection.I am having a issue trying ...

mkmead · 06-29-2020

I got it working! LOLSo as soon as I got done typing, that the old WAAS policy could be removed. I went and removed it. Soon as I did that it started working. I am guessing that policy was messing with ICMP inspection and breaking it.Thanks for your ...

mkmead · 06-29-2020

I tried adding the command. I did a test ping but it still fails. My machines IP is now .1884Jun 29 202009:33:01313004 Denied ICMP type=0, from laddr 192.168.17.5 on interface inside to 192.168.210.188: no matching sessionBelow is the test.. I can...

mkmead · 08-07-2014

I figured it out finally this morning.. you have to edit the default rule at the bottom of the Authorization rules screen. There is no implicit deny all.. its actually configured to default to "Permit"I edited it to "DenyAccess" and now its working ...

mkmead · 08-07-2014

Again, the issue is not that AD integrations are not working. AD is working fine and I can add groups and use them as the conditional statement in my Authorization rule set. The issue is that even with that rule properly set. Any user who is or is n...

mkmead · 08-07-2014

Thats already been done. AD works fine. The issue is that any user with a good username and password can still login to my router using a AD account. They shouldn't be able to do that at all.

Member Since	‎09-05-2002 07:55 AM
Date Last Visited	‎07-02-2020 10:53 AM
Posts	42
Total Helpful Votes Received	5

User Statistics

User Activity

ICMP in and out of the same ASA 8.2 interface fails (ASA is Default Gateway)

ACS 5.5 unable to use AD Groups for Identity Access Policy

Redistriubte BGP into OSPF via Route-map

Having problems setting up Auto Attendant (Call Handler)

Issue with PBR and EIGRP routing - Delay

Re: ICMP in and out of the same ASA 8.2 interface fails (ASA is Default Gateway)

Re: ICMP in and out of the same ASA 8.2 interface fails (ASA is Default Gateway)

I figured it out finally this

Again, the issue is not that

Thats already been done. AD