About eijorgeqwrer7244r5r

eijorgeqwrer7244r5r · 02-03-2020

Hello, I know this is a stupid question but I've been searching for a lot of time... I can't access the admin page of my Cisco switch and I do not know why. I can ping it, I'm connect to it but access to the admin page is filtered : $ nmap -Pn -p ...

eijorgeqwrer7244r5r · 02-06-2020

Yep! You were right!After investigation, it appears that a policy was missing in the firewall to allow the https traffic between my computer and the switch. Thanks!

eijorgeqwrer7244r5r · 02-04-2020

Hello, Thanks but I cannot go further :( $ nmap -Pn -p 22 10.1.0.11 Starting Nmap 7.70 ( https://nmap.org ) at 2020-02-04 11:55 EST Nmap scan report for 10.1.0.11 Host is up. PORT STATE SERVICE 22/tcp filtered ssh Nmap done: 1 IP address (1 h...

eijorgeqwrer7244r5r · 02-04-2020

Hello, Thanks again for the reply, but still, I do not understand your answer. How could I get these outputs from the switch if I'm unable to connect to the switch? That is my main problem : how to connect to the switch as these port are filtered? T...

eijorgeqwrer7244r5r · 02-04-2020

Hello marce1000, Thank you for your reply but I do not understand. I already have an IP assigned to the switch : 10.1.0.11My issue is that, for unknown reason, the ports are filtered. Is there any other port that I'm not aware of regarding the manag...

Member Since	‎02-03-2020 09:34 AM
Date Last Visited	‎02-07-2020 02:19 AM
Posts	5

User Statistics

User Activity

SG300-52MP : how to access config page

Re: SG300-52MP : how to access config page

Re: SG300-52MP : how to access config page

Re: SG300-52MP : how to access config page

Re: SG300-52MP : how to access config page