I'm running multiple CCME setups and am finding that all my fixed phones (7911/7931/7961/7965/7970) retrieve their time-zone information from the telephony-service section on the CCME router, which works fine.
However all my wireless phones (7921/7925) seem to show the same time as the router, and do not seem to pick up a time-zone at all. They just show the default time zone (UTC) when I check from the web interface of the phone.
The problem with this is we like to keep all our network infrastructure running on the same time-zone, but of course want the phones to display the time relevant to the local area.
This command works with the vendorConfig section of the Sep*.conf.xml configuration file, which is read by the phone firmware when the Cisco IP Phone is booted up. Certain phones, such as the Cisco Unified IP Phone 7906 , 7911, 7931, 7941, 7942, 7945, 7961, 7962, 7965, 7970 , 7971, and 7975, obtain Coordinated Universal Time (UTC) from the clock of the Cisco router. To display the correct local time, the time display on these phones must be offset by using this command.
This command is not required for Cisco Unified IP Phone 7902G, 7905G, 7912G, 7920, 7921, 7935, 7936, 7940, 7960, or 7985G.
For changes to the time-zone settings take effect, the Sep*.conf.xml file must be updated by using the create cnf-files command and the Cisco IP phones must rebooted by using the reset command.
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...
While gNMI is fairly new, it's becoming more and more powerful. Its abilities to simplify network management by the use of protocol buffer files and standard definitions are enabling our customers to integrate a lot ...
Today we are releasing to the public a tool to help find differences in command outputs in two points in time (IE pre and post MW).
The issues we are addressing is what commands to gather and how to successfully parse the data when timestamps, upti...