9T 10 sec. delay minimize ?

[shamudra2000]

I am using dest-pat 9T .By default it waits for 10 sec. So, how can I save/reduce this 10 sec without pressing # for termination ?

[vnebolsi · Accepted solution]

For CME put under telephony-service the following command:

timeouts interdigit 3 ! 3 secs interdigit delay

The changes are effective immediately.

Also if it's ISDN to public network, it make sense to add "isdn sending-complete" under ISDN interfaces, so network won't want for overlap sending.

/vnebolsi

[icabrera · Accepted solution]

Hi, you can change the interdigit timeout by using the timeouts inter-digit command in voice-port configuration mode.

See next url for more information:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvfax_c/int_c/dpeer_c/dp_plan.htm

Regards.

Please, rate if helpful.

[shamudra2000]

Thanks for your prompt reply. I will try it tomorrow & inform you.

Ragards

Aziz