07-02-2004 04:16 AM
Hi!
H323 terminal try to setup call to remote zone:
term GK1 GK2 GW
|---ARQ-->|----LRQ--->|
| | |
|<--ARJ---|<---LCF----|
GK2 (cisco 2600) sends to GK1 (cisco 3600) LCF message but GK1 rejects call:
value RasMessage ::= admissionReject :
{
requestSeqNum 3650
rejectReason resourceUnavailable : NULL
}
What does it mean?
May be this part of LCF is at the bottom of reject:
value LCFnonStandardInfo ::=
{
....
resources
{
maxDSPs 0
inUseDSPs 0
maxBChannels 0
inUseBChannels 0
activeCalls 0
bandwidth 0
inuseBandwidth 0
}
....
}
GK2 doesn't receive information about resources availability from GW.
Is it possible to around that sort of GKs behaviour?
Regards.
07-02-2004 10:19 AM
The resources availability is decided by the originating gatekeeper, if it allows the call to go through or not depending on the available resources. Do you have any resources availbity configured on the originating gatekeeper?
07-05-2004 04:54 AM
No I havn't. The configuration of the originating gatekeeper is simple:
gatekeeper
zone local gk2.foo.net foo.net xx.xx.xx.xx
zone remote gk.foo.net foo.net yy.yy.yy.yy 1719
zone prefix gk.foo.net 380*
zone prefix gk.foo.net 888*
no shutdown
07-06-2004 08:41 AM
This could be due to a couple of reasons
1. Due to unavailability of bw that GK is rejecting the call. Try configuring "bandwidth remote 1000" on the OGK
2. When there is no proxy configured the GK will also give the same ARJ reason..
you can try the following commands under the GK..
no use-proxy gk1 remote gk2 outbound terminal
no use-proxy gk1 remote gk2 inbound terminal
hope that helps
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide