Voice over IP

Hi allI would like to know if someone has testet a PGW2200 cluster with two different host models (same technology: AMD or SPARC). For instance X4600M2 as ACTIVE and a X4200M2 as STANDBY. Someone knows if this is a TAC approved configuration?. Many t...

I have a particularly tough scenario. We have a large utilities client that has several types of PBXs interfacing with channel banks to hand off large groups of OPX lines from analog DID trunks to ring specific analog handsets. The customer wants to...

Hi,I've CUCM 7.02 with H323 GW for one cisco 2811 with 2 FXO ports, and i cannot do a outgoing call.The call is placed and after 12 seconds the call disconect with " Cause Value=47, Tag=0x0, Call Entry(Previous Disconnect Cause=0, Disconnect Cause=4...

hi,my AS5300 logged a call was able to authorize, then stop accounting/originate was recived and then call was billed. but in a minute another stop accounting/originate was recieved with the same user-name and Called Station ID, but with different h...

Hi every one,What is the difference between 2 commands 'pri-group' and 'ds0-group'Thanks,yytellmey

I have an ata installed in a conference room that goes out from time to time. user's complain that there is not a dial tone. however a simply reset of the ata fixes the problem until the next conference call. besides the network connection, is there ...

Hi, Today my voice network works with dial-peers point to point using gateway cisco, This network is for two companies A and B, between company A dial direct ext to ext for each place, but for company B need to dial a code and the the extension, fo...

Consider the following configuration:voice translation-rule 78 rule 1 /.*/ /19047580977/!voice translation-profile 2214 translate calling 78!dial-peer voice 42 pots translation-profile outgoing 2214 application session destination-pattern 9047580977 ...

Unable to open Cisco communicator- user it getting error "CUPCS encountered a problem and needs to be closed"- user is not getting the login screen but getting the error messageEven after I remove the software and reinstall it this keeps happening. W...

Hello.I have 3 dial-peer in my configuration.I would like to block 2 of them if the total of calls of the third dial-peer is supperior or equal to a number (20 for example)I checked for the max-conn command, but its not exactly what I need.Anyone hav...

Hi all,Recently one of our AS5350's E1 stop working properly. The physical status is OK.E1 3/0 is up. Applique type is Channelized E1 - balanced Description: CIRCUITO LD No alarms detected. alarm-trigger is not set Version info of slot 3: HW: 5...