Bind to HSRP/VRRP IP

[Adam Shafran]

We have the below config on one of our routers and the IP of this interface is 192.168.25.1. We are trying to implement VRRP but this is causing the bind to be established to the physical IP of the interface, not the virtual IP. Is there any way to change the bind command to use the VRRP/HSRP IP instead of resolving to the interface IP?

voice service voip
 sip
  bind control source-interface GigabitEthernet0/0.100
  bind media source-interface GigabitEthernet0/0.100

[B.kablawi90]

There is no Virtual IP in VRRP.

VRRP uses the the physical IP address of one of the routers based on the highest priority and name it virtual router.

if you want to use Virtual IP you have to configure HSRP instead of VRRP where you can easily define the desired Virtual IP for your network.