cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2401
Views
5
Helpful
4
Replies

Cisco AS5400 SIP Trunk source port ?

mathieuploton
Beginner
Beginner

Hello,

Is there a command to fix the trunk signaling source port to 5060 in the Cisco AS5400XM ?

Thanks,

4 Replies 4

Karthik Sivaram
Enthusiast
Enthusiast

hi,

what's the exact issue?

IOS  can use random port as source port on SIP request.

However if you are running 12.3 then you cannot set it to one port.

Later 12.4(5a) and 12.4(6)T have following hidden command.

(config-sip-ua)#connection-reuse

This command sets used source port to SIP listen port.

It sets it to udp port 5060

Hope this helps!!

Thanks,

karthik

Hi Karthik,

If I use 12.3, How to change it without upgrade iOS?

Thanks,

Songtham

Thanks from the future!

Daniele Giordano
Collaborator
Collaborator

Hi, you can try to use the command 'listen-port' but was introduced in IOS version 12.4.

 

Regards.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: