07-06-2011 08:19 PM
Hello,
Is there a command to fix the trunk signaling source port to 5060 in the Cisco AS5400XM ?
Thanks,
07-10-2011 06:05 AM
hi,
what's the exact issue?
IOS can use random port as source port on SIP request.
However if you are running 12.3 then you cannot set it to one port.
Later 12.4(5a) and 12.4(6)T have following hidden command.
(config-sip-ua)#connection-reuse
This command sets used source port to SIP listen port.
It sets it to udp port 5060
Hope this helps!!
Thanks,
karthik
01-19-2012 10:26 PM
Hi Karthik,
If I use 12.3, How to change it without upgrade iOS?
Thanks,
Songtham
07-23-2018 09:28 PM
07-26-2018 05:02 AM
Hi, you can try to use the command 'listen-port' but was introduced in IOS version 12.4.
Regards.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: