10-22-2019 06:16 AM
Hi All,
I have 15 Cisco phones model SPA502G in the company and i'm connecting them to the PBX by IP address and subnet mask. Now i purchased new phone model 8845 but i couldn't registered the phone in the same way as it's required CUCM QR to register the phone but i don't have the Cisco call manager system and i'm not planing to have it as well. I just have one 8845 IP phone in the company. Is there any way to register the phone without using the Call manager system??
10-22-2019 02:35 PM
10-23-2019 12:28 AM
10-23-2019 02:16 AM
Had a look at the photo and the phone is loaded with Enterprise image.
You will need to convert the phone from Enterprise image to 3PCC: Cisco Cloud Upgrader
10-23-2019 06:30 AM
Hi again,
I wrote the IPv4 in the web to access the phone as it mentioned in the link but no phone page showing.
10-23-2019 01:51 PM
10-26-2019 04:13 AM
I already did all the steps mentioned in the link you have sent before but still the issue is the same. I'm attaching all the information from the phone for your reference
10-26-2019 04:50 AM
10-26-2019 04:58 AM
I already tried to upgrade the firmware by following the steps you shared in the link but the phone failed to upgrade. I sent you the screenshots after i tried to upgrade the phone.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide