cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
312
Views
5
Helpful
1
Replies

CME/CUE - Small problem with Extension/dial-peer

fxavier.cat
Level 1
Level 1

Hey Pros

System: CME Router 2811 3.3+CUE Module 2.2 + 2Cards FXO(4ports each)

I have a small question about dial-peer.

i have 2 kind of extension

1. (example:10,11,12,13...)

and

11. (example:110,111,112,113,...)

But when i dial the extension 110, actually it's dialing the ext. 11

dial-peer voice 10 voip

destination-pattern 1.

session protocol sipv2

session target ipv4:192.168.140.252

dtmf-relay sip-notify

codec g711ulaw

no vad

dial-peer voice 110 voip

destination-pattern 11.

session protocol sipv2

session target ipv4:192.168.140.252

dtmf-relay sip-notify

codec g711ulaw

no vad

thanks in advance

1 Reply 1

Brandon Buffin
VIP Alumni
VIP Alumni

One option would be to create one dial peer with a destination pattern of 1T, such as:

dial-peer voice 110 voip

destination-pattern 1T

session protocol sipv2

session target ipv4:192.168.140.252

dtmf-relay sip-notify

codec g711ulaw

no vad

CME would wait for the interdigit timeout to complete the call and send the digits. The interdigit timeout can be changed with the following commands:

telephony-service

timeouts interdigit 3 (changes timeout to 3 seconds)

Hope this helps. If so, please rate the post.

Brandon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: