Hi there,
So I'm trying to configure BLF on a Metaswitch VP3510 softswitch.
Currently I'm using the following config to program the line:
fnc=sd+blf+cp;sub=xxx@yyy.yyy.yyy.yyy;nme=xxx
xxx=extension
yyy=public IP of phone
The status of all the lines are currently a solid orange meaning the lines are not registered.
The lines are currently functioning as speed dial buttons but I cannot see the status of the line (in use / ready...etc).
I'm not sure if 'fnc=sd+blf+cp;sub=xxx@yyy.yyy.yyy.yyy;nme=xxx' is the right syntax. Not sure what nme is for or if I should be using something like 'usr' or 'ext' ..
I was wondering if anyone had advice on how to configure BLF on a Metaswitch system.
Any feedback would be greatly appreciated!
Many thanks,
-Jason