cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1370
Views
0
Helpful
1
Replies

Configure BLF on SPA500s sidecar

jasduval8
Level 1
Level 1

Hi there,

So I'm trying to configure BLF on a Metaswitch VP3510 softswitch.

Currently I'm using the following config to program the line:

fnc=sd+blf+cp;sub=xxx@yyy.yyy.yyy.yyy;nme=xxx

xxx=extension

yyy=public IP of phone

The status of all the lines are currently a solid orange meaning the lines are not registered.

The lines are currently functioning as speed dial buttons but I cannot see the status of the line (in use / ready...etc).

I'm not sure if 'fnc=sd+blf+cp;sub=xxx@yyy.yyy.yyy.yyy;nme=xxx' is the right syntax. Not sure what nme is for or if I should be using something like 'usr' or 'ext' ..

I was wondering if anyone had advice on how to configure BLF on a Metaswitch system.

Any feedback would be greatly appreciated!

Many thanks,

-Jason

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

Wrong forum, post in "small business p ip phones". You can move your post using the actions panel on the right.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: