cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
452
Views
0
Helpful
3
Replies

deb fax relay t30 level-2

rmafficini
Beginner
Beginner

Is there something to interpreter the result of deb fax relay t30 level-2 ?

I have some problem related to T38 fax Protocol, but I'm not able to understand where is the problem (Cisco 2811 & 2611 AS5400 PGW HSI GK enviroment)

3 Replies 3

Chester Rieman
Cisco Employee
Cisco Employee

Not really. This debug will show both t.30 and t.38 debugs.

It will show the actual t.30 or t.38 fax messages such as CNG,LCS and EOM.

You can find the state diagram for t.30 on the ITU site:

http://www.itu.int/rec/T-REC-T.30-199303-S/en

section 4.2 figure 9.

For PGW/HSI, you can either do GW controlled fax or call-agent controlled fax. If you have all cisco GWs, gw-controlled fax is simpler to configure.

If you are doing call-agent controlled faxing, make sure fax is enabled on the PGW/HSI:

http://cisco.com/en/US/products/hw/vcallcon/ps2027/products_feature_guide09186a00807dca5a.html

(t.38 is desirable rather that t.30)

A good overall doc:

http://cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_book09186a0080762024.html

Hope this helps

rmafficini
Beginner
Beginner

I have tried to decode a trace as suggest, but I have a lot of difficulties. Could you please help me decoding the below trace?

I'll try to use your example for the new one.

see atthaced trace.

thanks

Chester Rieman
Cisco Employee
Cisco Employee