dial-peer voip session target ras remove secondary dialtone

[jmize]

i have a pri circuit that contains the number NNX-XXX-7599.

i configured the pri , dial-peers.

the 7599 number is my meeting place 8106 server, registered to gatekeeper on the same router (3745) as the pri.

i am getting secondary dialtone.

when i dial the number from the co i get dial tone and have to enter hte last 4 digits again then the call connects

a cisco white paper says to add direct-inward-dial. this command is not available with dial-peer voice voip.

how can i get this number to connect directly through.

thanks for any help

Jeff

dial-peer voice 7599 voip

destination-pattern 7599

session target ras

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

ip qos dscp cs3 signaling

controller T1 2/0

framing esf

linecode b8zs

pri-group timeslots 1-24

description SBC BL PRI2 H.323

interface Serial2/0:23

no ip address

no logging event link-status

isdn switch-type primary-ni

isdn incoming-voice voice

no cdp enable

[k_vishwesh]

Can you post your full confgiuration

[jmize]

HI

I have a combination of MGCP and H.323 trunks

the trunk i am working with is 2/0

here is the config

thanks for any ideas

attached is the config

[adham2005]

Hi

You need to add a "POTS" dial-peer for the 2/0:23 Voice port matching somthing like this

dial-peer voice 455 pots

incoming called-num 7599 ! for example

direct-inward-direct

port 2/0:23

[jmize]

Not sure that will work.

the 7599 number is coming in on 2/0:23 and needs to point to RAS the gatekeeper.

but i will give it a try.

thanks