03-28-2008 07:42 AM
i have a pri circuit that contains the number NNX-XXX-7599.
i configured the pri , dial-peers.
the 7599 number is my meeting place 8106 server, registered to gatekeeper on the same router (3745) as the pri.
i am getting secondary dialtone.
when i dial the number from the co i get dial tone and have to enter hte last 4 digits again then the call connects
a cisco white paper says to add direct-inward-dial. this command is not available with dial-peer voice voip.
how can i get this number to connect directly through.
thanks for any help
Jeff
dial-peer voice 7599 voip
destination-pattern 7599
session target ras
dtmf-relay h245-alphanumeric
codec g711ulaw
ip qos dscp cs5 media
ip qos dscp cs3 signaling
controller T1 2/0
framing esf
linecode b8zs
pri-group timeslots 1-24
description SBC BL PRI2 H.323
interface Serial2/0:23
no ip address
no logging event link-status
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable
03-30-2008 04:46 AM
Can you post your full confgiuration
03-31-2008 08:07 AM
03-31-2008 05:22 PM
Hi
You need to add a "POTS" dial-peer for the 2/0:23 Voice port matching somthing like this
dial-peer voice 455 pots
incoming called-num 7599 ! for example
direct-inward-direct
port 2/0:23
04-01-2008 04:59 AM
Not sure that will work.
the 7599 number is coming in on 2/0:23 and needs to point to RAS the gatekeeper.
but i will give it a try.
thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide