GW5350 controller clock setting

[kieulam.nguyen]

Hi All,

My GW5350 is running System image file "flash:c5350-is-mz.122-2.XB7.bin"

I have connected back2-back to a Vocaltec gateway, my test calls are good quality with short PDD, with my controller default clock source line.

However for testing purpose, I cannot find command to change clock source, even cannot issue command

Router(config-controller)#clock souce line primary

As reommended in Cisco document.

Please advise me how to change clock source for the controller E1 in Cicso GW5350.

Thanks.

Kieu.

[arraman]

Hi Kieu,

what is the error do you get?

Also there is a typo error "source" in the command you have copied.

Thanks

Arun

[kieulam.nguyen]

Hello Arun,

Thanks for ur quick response, I cannot change the clock source for the controller when trying to connect back-to-back with Vocaltec gateway, here is the error:

HAN-5350(config)#controller e1 3/0

HAN-5350(config-controller)#clock source line primary

^

% Invalid input detected at '^' marker.

HAN-5350(config-controller)

Thanks,

Kieu

[i.fouraki]

Hi,

in as5350/5400s setting the clock source is different. In global config, use the command "tdm clock priority Z x/y", where Z is from 1-99, and x/y the slot/port combination of the E1 controller.

Y.

[kieulam.nguyen]

Hi Fouraki,

My gateway 5350 doesn't recognize that command.

HAN-5350(config)#tdm?

% Unrecognized command

HAN-5350(config)#tdm

[i.fouraki]

sorry, try dial-tdm-clock command