cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1146
Views
0
Helpful
3
Replies
chipsch21
Beginner

IAD2435 Sip to Analog

Hey everyone,

I am working on a solution for our office and was hoping to get some positive feedback here since I can't find much out on the web for this. We are looking at doing a T1 (MPLS) and a backup cable modem connection. There is also a requirement for a sip trunk that would hand off 6 analog phones. I am looking at the IAD 2435 since it does have the T1 controller embedded and the RJ-21 for analog phone lines. I can't find whether it supports vpn's and zone based firewall though which would be a requirement for the cable connectivity in the event of a failure. Also, can't find much on configuring the sip trunk and how to configure the voice ports. Any pointers or advice/snippets of config that may point me in the right direction would be great, thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
rotem.shein
Beginner

You will have to conf the following elements

Voice service VoIP

Codecs

Voice-port

Voip Dial-peers

Pots dial peers

Sip-ua

Sent from Cisco Technical Support iPad App

View solution in original post

3 REPLIES 3
rotem.shein
Beginner

You will have to conf the following elements

Voice service VoIP

Codecs

Voice-port

Voip Dial-peers

Pots dial peers

Sip-ua

Sent from Cisco Technical Support iPad App

View solution in original post

Thank you Rotem. I should have updated this post stating that I had already figured everything out but what you said was dead on. Thanks again!

you are welcome and good luck

Sent from Cisco Technical Support iPad App