iptoip gw isue

[teodor.dobrev]

Hi to all,

the problem is that on incoming voip dial-peer on a iptoip gateway the call is not redirected inwards to call manager. I see in voip ccapi that Final Destination flag is true. Any advice what can i do.

i will atach config and debug from voice ccapi inout. Incoming dial-peer is 106.

[paolo bevilacqua]

Hi,

doesn't look like you are running an Ip-to-IP Gw image. These are special images which filename ends in _isv. Also licensing is required. So that if you can make the CCM to conntect directly to the other device, it would be simpler.

Hope this helps, please rate post if it does!

[teodor.dobrev]

Hm,

that was what i tought initialy - but how it works in the outgoing direction?

I can make calls from CCM to the VoIP provider through the voice gw but not inwards.

It was working untill now exactly as you say directly from ccm to voip provider.But i had to change it due to some unresovable isues with the 3th pafrty billing system:)

Any other thoughts?

[paolo bevilacqua]

Hi Teodor,

not sure why it works in one direction only. Would you try "debug voice dialpeer". On the other hand I'm confident you have configured the DP correctly.

[teodor.dobrev]

Hi,

Again

here is the debug:

*Jul 5 06:46:58.664: //-1/4D7D51EFB63A/DPM/dpAssociateIncomingPeerCore:

Calling Number=6026, Called Number=4026, Voice-Interface=0x0,

Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search Type=PEER_TYPE_VOICE,

Peer Info Type=DIALPEER_INFO_SPEECH

*Jul 5 06:46:58.664: //-1/4D7D51EFB63A/DPM/dpAssociateIncomingPeerCore:

Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming Dial-peer=106

*Jul 5 06:46:58.664: //-1/4D7D51EFB63A/DPM/dpAssociateIncomingPeerCore:

Calling Number=6026, Called Number=4026, Voice-Interface=0x0,

Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search Type=PEER_TYPE_VOICE,

Peer Info Type=DIALPEER_INFO_SPEECH

*Jul 5 06:46:58.664: //-1/4D7D51EFB63A/DPM/dpAssociateIncomingPeerCore:

Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming Dial-peer=106

So it matches on the incoming dial-peer 106 and that's it it should go to dial-peer 10 but no:)

I've checked what you told me about ios and you may be right so i'll find a good time now to test with 12.4(9)T-ivs.

Will keep you informed.

Thanks

[teodor.dobrev]

Hi,

I solved it. You see that codec command on the dial-peer:)

Man it killed me.

Thanks for the help.