12-06-2005 05:41 AM
VWIC-1MFT-E1 working on 2811.2 PVDM2-16 on router.incoming call TS 1-15 connection no problem voice ok.But Time slot up to 16 is problem.Connection ok but not work voice.
12-09-2005 12:50 PM
Depends on codec complexity being used. Do show voice dsp to see dsp resources.
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c333.shtml
Hope this helps,
Chester
12-13-2005 03:23 AM
On PRI 16th timeslot is reserved for signaling - do sh isdn service to figure out which slots are available.
Brani
Example:
PRI Channel Statistics:
ISDN Se1/0:15, Channel [1-31]
Configured Isdn Interface (dsl) 0
Channel State (0=Idle 1=Proposed 2=Busy 3=Reserved 4=Restart 5=Maint_Pend)
Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
State : 0 2 2 0 0 2 2 0 0 0 0 2 0 2 2 3 2 2 0 0 3 3 3 3 3 3 3 3 3 3 3
Service State (0=Inservice 1=Maint 2=Outofservice)
Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
State : 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2 0 0 0 0 2 2 2 2 2 2 2 2 2 2 2
01-02-2006 02:15 AM
Can you send me the configuration of the router ? I have a problem whit the configuration of the E1 card.
Thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: