I have successfully place a call from Netmeeting to PBX using codec on Netmeeting G711aLAW.
The Netmeeting side is modem-Dialup(56Kbps), but the voice is distorted as G711aLAW requires 64Kbps.
Question:
I want to use codec G723.1 (6.4Kbps) on Netmeeting to dial a PBX, but call not placed.
My Question is that can I assign a codec G723r63 on pots, so that Call will connected from Netmeeting to PBX using Codec g723.1.
Conf:
voice-card 2
codec complexity high
!
isdn switch-type primary-net5
!
!
voice service voip
h323
h245 tunnel disable
h245 caps mode restricted
!
controller E1 2/0
clock source line primary
pri-group timeslots 1-31
!
interface Ethernet0/1
ip address 62<omited> 255.255.255.0
full-duplex
no cdp enable
!
interface Serial2/0:15
no ip address
no logging event link-status
isdn switch-type primary-net5
isdn incoming-voice voice
isdn outgoing display-ie
no cdp enable
!
voice-port 2/0:15
bearer-cap Speech
!
dial-peer voice 13 pots
destination-pattern ...........
port 2/0:15
!