cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
445
Views
0
Helpful
1
Replies
patricianet
Beginner

no audio because of nat

I am trying to set up my router and I have it at the point where I can call my phones but I get no audio. When I run my sniffer I see sip and register messages but I do not see any rtp from behind my router.  I am trying to send voice traffic to s0/1 and data to s0/0.  It looks like a nat issue but I can not put my finger on it.

1 REPLY 1
Chester Rieman
Cisco Employee

What device is doing NTA?  I has to be aware of and perform the translations for RTP as learned from the signaling protocol.

For example, if a PIX were doing the NAT and the signaling was done via H323, the fixup protocol h323 command would enable this.

Hope this helps....