Problems with Cisco Attendant console - Cisco Community

1136

Views

0

Helpful

2

Replies

Highlighted

Hello to all ,

I have a server with Cisco CallManager 4.0 . I was installed cisco Attendant console , but now I have a problem : users cant authenticate :

The message is : Invalid password , please try again .

Can you help me ?

Thanks and best Regards .

Hugo Baez

2 REPLIES 2

Wrong forum, try "ip telephony".

Thanks Paolo , I will close this case and open another

best regards

Latest Contents

Introducing IOS XR Maintenance Window Checker

Created by smilstea on 01-15-2020 01:30 PM

0

0

0

0

Today we are releasing to the public a tool to help find differences in command outputs in two points in time (IE pre and post MW). The issues we are addressing is what commands to gather and how to successfully parse the data when timestamps, upti... view more

mVPN Profile 14 on NCS55xx - How to configure + verify contr...

Created by Bruno De Oliveira Novais on 12-30-2019 08:10 AM

6

0

6

0

Introduction In this document, I will go over how to verify control plane and data plane programming on ncs55xx. This profile is becoming the most favorite on this platform because of the use of partitioned mdt, and the fact it can scale easily using ml... view more

IOS XR eXR - Viewing Install Repository LXCs LVMs Partitions...

Created by smilstea on 12-05-2019 10:15 AM

0

5

0

5

This guide will explain how to check where a particular directory resides within the filesystem in terms of physical disk, logical volume, volume group, etc by taking a look at where the install repository actually resides on an NCS5500. ... view more

Behavior change: EVPN ESI Label encoding in BGP Extended Com...

Created by nkarpysh on 12-03-2019 05:53 AM

0

5

0

5

Introduction According to the RFC 7432: Extended Community enables split-horizon procedures for multihomed sites. The ESI Label field represents an ES by the advertising PE, and it is used in split-horizon filtering by other PEs that are connected to th... view more

EVPN Constructing Ethernet Segment Identifier (ESI)

Created by nkarpysh on 10-08-2019 03:13 PM

0

0

0

0

Hi All, In scaled EVPN deployments it can be wise to name ESI that way to represent the site/physical port/etc it is attached to. Thus on some remote location you can easily verify where particular route/MAC is coming from. Similar to phone numbers, where... view more

CreatePlease to create content