11-23-2006 09:32 AM
I have setup 3 voice gateway router to 3 PBX in 3 remote offices. Routers have FXO, FXS & E&M ports connected to PBX. We are exchanging some PBX extensions with other PBX by configuring router FXO-FXS trunk. I also configured tie line by E&M ports.
My problems are:
1. Sometimes few FXS ports are not getting remote PBX dial-tone & hang. If we shut/ no shut or reboot the router then it works fine again.
2. Sometimes following message is coming from my E&M port & the call is not going by this port. ""*Nov 21 07:34:21.789: flex_dsprm_tdm_xconn: voice-port (0/0/0), dsp_channel(/0/4/5)""
But I have DSP allocated to all voice ports. Do I need more DSP ?
3. Sometimes when we put access code to call remote office by E&M ports, it can?t place the call, although the line is free. If gives a busy like tone.
4. Though my ping time is 12ms but a call by E&M port takes 3 seconds to ring. How can I reduce this delay time?
I am very much worried about this problem. Please help me to solve these problems.
11-29-2006 11:33 AM
11-30-2006 03:03 AM
gateway and IOS aside. How many voice ports do you have in your router ?
a sh voice prt summ will let you know if any problems. are they all in service?
with regard to your E&M - what type are you using? 2 or four wire ? for UK type five E&M is best, beware this is often annotated as type 1 by PBX vendors. Also, for your e&m lines, for call setup if you can afford the bandwidth change the config from tie-line to trunk with sig immediate. Difference being tie-lie has to build the cct prior to signalling which will take time but consumes no bandwidth when dormat - opposite is true of trunk. by the way what value do you have for your inter digit timer? As a way to resolve quickly down your fxs/fxo's . Setup a single e&m line as above insure your policy is appropriate and applied. make and recieve a call. If speech quality seems ok try a fax as well, moitor from CLI your policy for drops and errors if seen, then debug. hope this helps. if you can - post your sigificant run cfg output for both ends. it would help me help you. good luck.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: