06-15-2010 07:16 PM
Hi there, i am trying to set up the following system
analog commander pbx ---> linksys8800 ---> internet
it seems to work fine when the internet is connected, but i would like it to failover and kick back onto the old ptsn line when the net is down.
i know this is possible with an asterix server but i dont know how to configure a normal old line on the spa8800? when i pull the ethernet cable it just sounds engaged.
i hope this is possible.
im a bit of a newbie as you can probably tell!. thanks in advance for your help.
06-16-2010 02:18 AM
Voice tab > Line page >
VoIP Fallback to PSTN section (SPA3102 and SPA8800)
On the SPA8800, these settings are configured on the Phone pages only.
Auto PSTN Fallback : If enabled, the ATA device automatically routes all calls to the PSTN gateway when the Line 1 proxy is down (registration failure or network link down).
The default is yes.
http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/ata/administration/guide/ATA_AG_v3_NC-WEB.pdf
hope this helps
M.D.
06-16-2010 06:13 PM
thanks very much for your help. it seems to be half working but i sitll have an issue wth the net side of things,
When the power is removed from the spa8800 it failsover to the ptsn line well,
but when i remove just the ethernet, it doesnt want to failover, just gives me an engaged signal... any ideas?
i have set the following settings to the line page thinking this might help but doesnt seem to change.
Make Call Without Reg: yes
Ans Call Without Reg: yes
Register: no
All i am getting is an engaged signal when the net is down..
i assume it doesnt need to register with a device as it is analog.
is there something i am missing here?
thanks very much for your help. almost there!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: