On a 2950 switch with identical port config one phone do not send periodically cdp mesages (not checked on monitoring session, only with sh cdp nei command on the 2950 switch), which results trust device lost event.
it seems the phone tries to get IP address in the access vlan not in the voice vlan. (discards the cdp packet sent by the switch?)
This phone should autoregister to the ccm 4.1(3)sr5. Autoregistration works on other switches.
If I configure this phone on the ccm, it starts working, it sends cdp more often - in every 120 sec the the cdp hold time restarts.
When the voice VLAN feature is enabled, it allows voice traffic from the attached IP phone and data traffic from a daisy-chained PC to be transmitted on different VLANs. This capability provides flexibility and simplicity in IP address allocation and prioritizing voice over data.
Untagged traffic is sent according to the default Class of Service (CoS) priority of the Catalyst switch port. The CoS value is trusted for 802.1p or 802.1q tagged traffic.
The voice VLAN feature enables access ports to carry IP voice traffic from an IP phone. The switch can connect to a Cisco 7960 IP phone and carry IP voice traffic. Because the sound quality of an IP phone call can deteriorate if the data is unevenly transmitted, the switch supports QoS based on IEEE 802.1p CoS.
QoS uses classification and scheduling to send network traffic from the switch in a predictable manner. The Cisco 7960 IP phone is a configurable device and you can configure it to forward traffic with an 802.1p priority. You can configure the switch to trust or override the traffic priority assigned by a Cisco 7960 IP phone.
The Cisco 7960 IP phone contains an integrated three-port 10/100 switch. The ports are dedicated connections to these devices:
Port 1 connects to the switch or other VoIP device.
Port 2 is an internal 10/100 interface that carries the IP phone traffic.
Below is a link to a video showing how to analyze traceroute output in L3VPN and look up CEF forwarding and MPLS/TE/SR/SR-TE forwarding for labels through a domain. Some basic examples of traffic engineering are used but the concepts lend the...
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....
The following pre-requisites are necessary for the migration from RSP440 to RSP880-LT to be successful.
Make sure that you have console access to the router.
Verify that the system is running a minimum o...
BGP flowspec in a nutshell is a feature that will allow you to receive IPv4/IPv6 traffic flow specification (source X, destination Y, protocol UDP, source port A .. etc) and actions that need to be taken on that traffic (...
IntroductionWhile gNMI is fairly new, it's becoming more and more powerful. Its abilities to simplify network management by the use of protocol buffer files and standard definitions are enabling our customers to integrate a lot better in multi-vendor envi...