04-20-2011 03:47 AM
I have configured CUE and i can call from internal and can listen the greeting message. but when i call from any other pstn number to main line (2811 cisco router acting as h323 Voice Gateway) calls have been dropped.
I call from ip phone to pstn (outgoing is ok) but problem is in incoming call.
Any clue???
CONFIGURATION is as below
boot-start-marker
boot-end-marker
!
card type e1 0 2
logging message-counter syslog
enable secret 5 $1$7SY2$Zwgh/Il4qYxg9DOFHpST.1
!
no aaa new-model
clock timezone GMT 4
network-clock-participate wic 2
network-clock-select 1 E1 0/2/0
!
dot11 syslog
ip source-route
!
!
ip cef
!
!
!
no ip domain lookup
multilink bundle-name authenticated
!
!
!
!
isdn switch-type primary-net5
!
!
voice call send-alert
voice rtp send-recv
!
voice service voip
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
h323
sip
bind control source-interface Loopback101
bind media source-interface Loopback101
registrar server
!
!
voice class codec 1
codec preference 1 g711alaw
codec preference 2 g711ulaw
codec preference 3 g729r8
!
!
!
!
voice class h323 1
h225 timeout tcp establish 3
!
!
!
!
!
!
!
!
!
!
voice register global
mode cme
source-address 10.1.211.1 port 5060
max-dn 100
authenticate register
!
!
!
voice-card 0
dspfarm
dsp services dspfarm
!
!
application
global
service alternate default
!
!
log config
hidekeys
!
!
!
!
!
controller E1 0/2/0
framing NO-CRC4
pri-group timeslots 1-10,16
!
!
!
!
!
interface Loopback101
ip address 10.1.211.1 255.255.255.192
h323-gateway voip interface
h323-gateway voip bind srcaddr 10.1.211.1
!
!
interface Serial0/2/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn incoming-voice voice
no cdp enable
!
interface Integrated-Service-Engine1/0
ip unnumbered Loopback101
service-module ip address 10.1.211.62 255.255.255.192
service-module ip default-gateway 10.1.211.1
no keepalive
!
router eigrp 1
network 172.16.40.0 0.0.0.3
network 172.16.250.24 0.0.0.3
network 192.168.84.0
no auto-summary
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 172.16.40.1
ip route 10.1.211.62 255.255.255.255 Integrated-Service-Engine1/0
ip route 172.16.250.12 255.255.255.252 172.16.250.25
ip route 172.16.250.28 255.255.255.252 172.16.250.25
no ip http server
no ip http secure-server
!
!
!!
!
control-plane
!
call fallback active
!
!
voice-port 0/2/0:15
bearer-cap Speech
!
no ccm-manager fax protocol cisco
!
no mgcp package-capability res-package
no mgcp timer receive-rtcp
mgcp fax t38 ecm
!
sccp local Loopback101
sccp ccm 10.50.2.3 identifier 1 version 7.0
sccp ccm 10.50.2.4 identifier 2 version 7.0
sccp
!
!
dial-peer voice 1 pots
incoming called-number .
direct-inward-dial
!
dial-peer voice 10 pots
tone ringback alert-no-PI
description International
destination-pattern 900.T
fax rate disable
port 0/2/0:15
prefix 00
!
dial-peer voice 11 pots
tone ringback alert-no-PI
description Emergency
destination-pattern 9600....
fax rate disable
port 0/2/0:15
prefix 600
!
dial-peer voice 12 pots
tone ringback alert-no-PI
description Emergency
destination-pattern 9800....
fax rate disable
port 0/2/0:15
prefix 800
!
dial-peer voice 13 pots
tone ringback alert-no-PI
description Mobile
destination-pattern 905........
fax rate disable
port 0/2/0:15
prefix 05
!
dial-peer voice 14 pots
tone ringback alert-no-PI
description National
destination-pattern 90[234678].......
fax rate disable
port 0/2/0:15
prefix 0
!
dial-peer voice 15 pots
tone ringback alert-no-PI
description Local
destination-pattern 9.......
fax rate disable
port 0/2/0:15
!
dial-peer voice 16 pots
tone ringback alert-no-PI
description Emergency
destination-pattern 9...
fax rate disable
port 0/2/0:15
!
dial-peer voice 100 voip
description To CallManager Pub
preference 1
destination-pattern [789]..
voice-class codec 1
voice-class h323 1
session target ipv4:10.50.2.3
dtmf-relay h245-alphanumeric
req-qos guaranteed-delay audio
acc-qos guaranteed-delay audio
fax-relay ecm disable
fax rate 14400
fax nsf 000000
fax protocol pass-through g711ulaw
no vad
!
dial-peer voice 200 voip
description To CallManager Sub
huntstop
preference 2
destination-pattern [789]..
voice-class codec 1
voice-class h323 1
session target ipv4:10.50.2.4
dtmf-relay h245-alphanumeric
req-qos guaranteed-delay audio
acc-qos guaranteed-delay audio
fax-relay ecm disable
fax rate 14400
fax nsf 000000
fax protocol pass-through g711ulaw
no vad
!
!
gateway
timer receive-rtp 1200
!
!
!
call-manager-fallback
max-conferences 8 gain -6
transfer-system full-consult
ip source-address 10.1.211.1 port 2000
max-ephones 42
max-dn 144
!
!
line con 0
speed 115200
line aux 0
line 66
no activation-character
no exec
transport preferred none
transport input all
transport output lat pad telnet rlogin lapb-ta mop udptn v120 ssh
line vty 0 4
password xxxxxx
login
!
scheduler allocate 20000 1000
ntp server 89.188.26.129
end
04-23-2011 01:44 AM
To make sure, are you having problems with all inbound calls, or just to the CUE pilot? I don't see a voip dial-peer configured to connect calls to the service engine. I've included an example below that may help.
dial-peer voice 300 voip
description CUE Voicemail Pilot
destination-pattern *YOUR CUE PILOT*
session protocol sipv2
session target ipv4:10.1.211.62
dtmf-relay sip-notify
codec g711ulaw
no vad
If you're having problems with inbound calls in general, can you post a 'debug isdn q931' so we can verify the calls are hitting your gateway and the telco is sending the correct number of digits?
--
Steve H.
05-08-2011 03:13 AM
Thnx for ur reply...can we do the same by creating translation rules??? If so, then what will be the rule
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide