Allow view_access to diagnostic logs to see call channel info

[Brian Rapier]

I have certain users that need to know what PRI channel a call is coming in on for emergency/911 trace info.

I found that they can see this info if they have access to the "Show diagnositic log" at this address on the UC http://10.1.100.1/exec/show/log/CR

I am trying to give access to an account that is not level 15 and I am not having any luck.

Is there a way to allow them to see this page without level 15 access?

Or is there another way to see this info?

Thanks

Brian

[paolo bevilacqua]

Router does not keep this information unless you configure deug, or detailed call logging, and I'm not even sure if the channel No. is sent in log.

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080094e72.shtml

[Brian Rapier]

I played with the CDR files, they are a bit more complex then we need for this.  Plus I could not get the UC to talk to the ftp server, causing the flash to fill with CDR files...

The website I listed shows this in the logs:

047981: Feb 13 07:27:05.050: %ISDN-6-CONNECT: Interface Serial0/3/0:20 is now connected to Unknown N/A

047982: Feb 13 07:27:13.630: %ISDN-6-DISCONNECT: Interface Serial0/3/0:20  disconnected from Unknown, call lasted 8 seconds

047983: Feb 13 11:41:34.661: %ISDN-6-CONNECT: Interface Serial0/3/0:18 is now connected to 9055555555 N/A

047984: Feb 13 11:42:00.025: %ISDN-6-DISCONNECT: Interface Serial0/3/0:18  disconnected from 9055555555 , call lasted 25 seconds

The bolded info is the channel the 911 operators need to do the trace.  Granted the 2nd example actually shows the CLID so its not needed. 

I just want to give a user access to that webpage without giving level 15 access.  Is that possible?  If not I will look into another way to access this data.

Thanks