Voice Systems and Accessories - Small Business

Recently installed a UC540 and I've noticed that the UC540 is severely capping our broadband speeds.We have a 100MB connection here presented by a virgin modem.When connected via the UC540, the best speeds we see (with inspection & ACL's disabled) is...

Dear all, How do I make redirects each incoming calls from PSTN lines via the FXO port 0 to port FXO others already incorporated (I mean port 1 until port 3 made into one port group? So the core of my question, how to make redirects call the FXO port...

The "**#" trick to "unlock" that I could use on the 50x series no longer works on the 514g.  Maybe it's because the firmware I tested that on was 7.4.8a and the 514G doesn't go below 7.5.2b. Anyone have any ideas on how to factory reset, or change t...

Is there a way to turn off the following tone: When i'm calling on my Cisco ATA-112, i hear a tone when someone else is ringing me on that line. I get the tone every couple of seconds during my call, till the moment that the person that calls hangs t...

Hello- Does anyone have a caller receiving feedback when they call in?  I've had multiple people tell me there is feedback when they call in and I'm on my headset. Is there a solution for this? Thank you!

Hi, I got a weird behavior on my UC560.  We have some extension forwarded to external number we are using as quick dial. Ex 751 goes to 95145555555 About half of the time, when we dial one of those "speed dial", the call disconnects as soon as it'...

I am not a cisco guy... im needing help with the AA on a UC560.. the changes i've made to the scripts dont seem to be taking affect when i put them in place.. i've tried to use just the web interface but it lacks all the features of the cca.. when i ...

I am not a cisco guy... im needing help with the AA on a UC560.. the changes i've made to the scripts dont seem to be taking affect when i put them in place.. i've tried to use just the web interface but it lacks all the features of the cca.. when i ...

I am not a cisco guy... im needing help with the AA on a UC560.. the changes i've made to the scripts dont seem to be taking affect when i put them in place.. i've tried to use just the web interface but it lacks all the features of the cca.. when i ...

I'm looking for a way to use Plantronics Savi 730W headset with  Cicso SPA525G bluetooth. On pairing, SPA525G shows Savi base station. After entering pin 0000 and pressing Connect in Cisco, Connect fail  message appears. How to connect Savi base t...

Hi,I've faced up a issue on 136 Cisco SPA504G with firmware 7.5.2 and 7.5.4, which I wish  to share with you in order to get help from you.In one moment, we started to receive claims from our users who were saying " they couldn't dial nor received an...

We have some SPA504g phones that often handle multiple incoming calls on a single line. If a second call begins ringing while the phone is on a call, and the call is then answered, the soft keys are blank for the second call. The softkeys defined for...

I have had no luck in finding why my red light (voicemail) on the top of my SPA942 will not go out. I check and delete all messages, but it remains. I thank you very kindly for any opinions that wish to be shared

hello guys, I've got a cisco SPA525G2 with firmware 7.6.1 and bt firmware up to 0.00.34 which is sometimes locking when Bluetooth is used with a iphone. Sometimes I can't hang up a call, I must disconnect the phone... Phone is used in SIP. Could it...