Voice Systems and Accessories - Small Business

I can't seem to create a new discussion thread for this below: no idea why!! I tried twice.. (now it works..) I have 4 questions regarding Park Softkeys: PSK 1: fnc=sd;ext=70@192.168.1.111;vid=1;nme=Park1) Can I replace 192.168.1.111 by writing exact...

We recently installed the last of our phones and I noticed that the backlighting for it is a lot brighter than ALL the other phones.  I think the other phones used to be this bright at the beginning too.I also noticed the setting on all the other pho...

Hi All,I'm hoping somebody can help me here.  I have an SPA112 telephone adapter that gives me problems with the phone not going off hook to give me a dialtone.I upgraded the firmware to 1.3.5p recently, thinking this might fix the issue.  It didn't,...

Hi – I put the password in for the voip (provided by ISP) but then got to this screen. Now I cant even login into the config of the phone.  I have added the screen dumps below as attachments. I am not sure where I am meant to enter the settings:Passw...

Hi there,I have several SPA3102s in my enviroment that I am using to connect legacy PSTN lines to the VoIP network. Calls come in on the PSTN lines and are routed to our Asterisk server by the gateways. The Asterisk server connects the calls to the c...

I have an issue with a Cisco SPA504g handsets connected to an Elastix server. I have the same issues at two different locations. One location the service phone connects to an SF100D-16P and a Billion 7800NXL. The other location is connected to a Netg...

Bonjour, Cisco SPA504GBonjour,J'ai une premiere ligne en communication et j'ai le bouton transfert qui apparait sur l'ecran.Une deuxiemle ligne sonne.Je suis toujours en communication avec la premiere ligne mais le bouton transfert à disparu.A la p^l...

Hi all, I have a problem with a Cisco IP Phone SPA502G.At boot time, it immediately lights up 3 buttons, the speaker, the headphone and the mute, and it freeze. I haven't done any upgrade to the configuration or firmware. Thank you very much for any ...

Hi I'm confusedI have downloaded 3 versions of the SPC for the spa50x, and run the sccp versionWhen I open it up one of the first lines I see (line 13 in the latest version) is<Signaling_Protocol ua="na">SIP</Signaling_Protocol> <!-- options: SIP/SPC...

I apologize for the simplicity of my request.  However, this is my last resort.  Is there a way on the 525g to transfer straight to voicemail without having the receiving receiver ring?Also, is there a way to alter inter office call ring tones?  I am...

I have a strange problem and would appreciate help.I have setup DHCP on windows server 2012. I have created scope policy based on Vendor class. The network is based on Linksys srw224g4 and Cisco sf300 switches.When I connect Linksys SPA942 or SPA962 ...

I have finished installing 2 new BE6K's a week ago and they are in production now. I just received the secondary power supplies for both so can I install them while in production without causing service interuption or do I need to schedule down time ...

I manage a small office with approx 12 SPA504Gs I have spent time setting up correct provisioning to ensure all phones get the latest updates and this works on most phones. However there are 4 phones in the office that are stuck on an older version. ...