Voice Systems and Accessories - Small Business

Hi guys,I have a question regarding the UC500 models.Would it be possible to use an analog line with the UC500?I've used SPA3000 till now and I'd like to integrate a UC500 with multiple analog lines.Has anyone had this scenario before?Thanks.Regards

How can I assign one of my inbound DIDs, coming into my UC560 from my carrier's PRI, to be used for an analog device, such as a fax machine?Do I do this by defining one of the FXS ports (i.e. 0/0/0) for a fax device?   Do I then need to connect FXO p...

Is it possible to have my attendant station show a DND status of another extension? I have been successful in the past with the UC540W using the "WATCH" on extensions. Would this require a PMF?

We are having a problem with a SPA525G2 and a UC540.When the system was first installed, the phone was configured for remote using the Cisco Configuration Assistant. The phone functioned remotely for almost one year, then stopped unexpectedly .The ph...

                   System has been install for a couple of years.  Recently Several users are attempting to change their voice mail greeting.  User goes through the process, saves changes.  They then go ahead and call to test.  The greeting has not c...

Hi,We have a very annoying problem with the Cisco SPA-5XX models. As soon as an incoming call is Anonymous, the information in the From header is not being displayed on the phone. This is annoying because this From header contains information from, f...

I configured the ATA exactly step by step anbd I did follow the guidelines of my voip provider (voip.ms).I see I am registered, everything works well, I get the dial tone, I can dial but then nothing happens.  I checked the dial plan  and tried sever...

Dear Team, Cheers!!!  I am facing a strange and interesting issue in Cisco UC560. On every saturday morning I was getting a complaint call from my client telling there International calls not going (when they are dialing prefix (9) 00 then next numbe...

Is this possible to do?We have a client that currently has two branch offices and a UC540 at each.  They are consolidating these two branches into one office now.  The combined phones will exceed the UC540's 32 user limit.  So, can the two UC540 unit...

Is it possible to configure NAT hairpinning/loopback on the UC540? We have the need to be able to access some of our forwarded ports through our public IP address from within the network. My dinky D-Link at home does this by default.

Hi All,up to me the above combination is currently not supporting the "Call Completed Elsewhere" stuff specificed in RFC3326. Am i missing some configuration here or am i correct with my assumption? If the latter is the case, are there any plans to s...

I am upgrading a customer from a UC540 BRI to a UC560 with a BRI card and ISDN30.  Is there an easy way to convert the config from the UC540 to the UC560?

Hi all, I set up the line key 2 of a SPA504g to monitor/call an extension this way :(Asterisk PBX is used)  fnc=blf+sd+cp;sub=5004@$PROXY;nme=Grandstream;vid=1When I want to transfer the current call to extension 5004 , I simply press that line keyTh...

Is this possible to do?We have a client that currently has two branch offices and a UC540 at each.  They are consolidating these two branches into one office now.  The combined phones will exceed the UC540's 32 user limit.  So, can the two UC540 unit...

Is there a way to change what the source phone number is after it is forwarded?The business I am helping has the phones forwarded after hours to cell phones.  The problem right now is that when the after hours calls are forward the source number is t...