Voice Systems and Accessories - Small Business

I want to upgrade the flash to 2gig. I formated the new flash FAT, then I copied the flash to a file on my hard drive then onto the new flash. I installed the flash & the UC520 booted up. I am able to see the config, the new backgroud we made comes u...

I have done this once before but dont have the notes. I think I have a bad CF card and want to replace it.I remember that I only need to put a minimal bit of software onto the card in order to boot it up and be able to run CCA and the software pack u...

We have a new client that has a UC540 and did not know the password for it.  We did a password recovery by booting it up without loading the startup config and set our own password.Since then several issues have been popping up.  The first was that t...

Hello all,I have read many threads on language selection within the forum and there seems to be no consistency.We have a couple of SPAs which are now running 7.5.5. The trouble is, we also cannot use any other language than English.Our SPA525er seem ...

We recently installed the UC320W system and are looking to add a second SIP provider as a failover for outbound calls if our primary provider is unreachable.  We were looking for an inexpensive option and want to give SIP Affinity a try.  I setup an ...

I have a customer that wants to install a new phone system. They have about 25 employees in the office, and another 80 external users.The internal users will each have a phone on their desk, where the external users will simply have any call for them...

                Are the spa232d usable with UC540? Not only throuth the analog interface but throuth voip interface?

Hi, I was trying to configure Traps Manager on my UC560. I attach the error message I got. It asked me to choose at least 1 trap but I didn't see any option to choose.Some details of my CCA:Running on Windows 7Version 3.2(2)

I have a question about my 504G. It will not complete post. When plugged into POE it starts, the Mute, headset & speaker lights come on. Then the display comes on as well as the Line keys. The line keys are orange and go out after 10-15 seconds and t...

Hi there,             I need to configure UC560 System with 10 to 12 teleworker sites with 5 users in each of the teleworker site and 20 users at the Main site (HQ). Can I use SPA8800 gateway in teleworker site to connect to HQ UC560? Thanks

Good day,I have SPA122 connected to dual WAN balance router. SPA is working perfect and no any problems with calls but...When I lose one Internet source (primary) and  balancer switches to another source (secondary) modem cannot get registration agai...

I’ve just bought SPA8000 for my customer. And I am surprised with the noisy, created by fan of this device. None of fans in any server, switch or other devices I am working with is so loud. It is crazy, somebody has accepted such construction. Anothe...

                   I am trying to use 7925G wireless handsets with a UC560. I have a CT2504 controlling the WAP. VLAN 1 is 192.168.10.x/24, VLAN 90 is 10.1.10.1/30, VLAN100 (voice) is 10.1.1.x/24. Switch ports have smartports set for AP, or phone+des...