Hi,I have a SIP provider that my pap2t is registering to and can originate outgoing calls just fine. I have a DID from the same provider that inbound routes to any SIP registered device or software. The pap2t never rings nor when I pick up the phon...
HiI plan to buy some SPA50 series to be used with Asterisk.One of the main feature is to allow some telephones to intercept calls of other. But I would like people to be able to read the caller ID before intercepting.I herad the SIP protocol does not...
I have configured a uc320w, added the FXO as a trunk and included it in the outbound calling option, made sure that the user privileges allow the calls to be made by the user, however, when I attempt to make a call it either cancels the call before I...
For some reason I'm only able to get the AA to work in PBX mode. If I try Blend or Key System, when someone calls in, the line rings it seems like the AA picks up but I get silence. I would like to use the Key system config.
Hi!I am new to forum and this is my first post regarding UC520. My UC520 was configured with CCA 3.2.2 and this is my first setup of cisco PBX.Software pack on UC520 is:SoftwarePackReleaseTimeframeIOSCMECUECompatibleCCA8.6.12012-NOV15.1(4)M58.68.6.53...
Hi,We have three numbers of SPA501G IP Phones with IP numbers 192.168.113.3/5/8. Now i want to make call between these phones with IP address. I am unable to make call with IP address. Can you help all the settings required in SPA501G configuration u...
Which family of telephone sets do the UC 540 and UC 560 support?? I am aware of the SPA 300 and SPA 500 and most, if not all, of the 7900 series can be installed on the UC 540 and 560, but I need to confirm that they can be configured through the CCA...
Our SIP service provider allows me to specify the calling line identification (CLI) for outgoing calls by placing the appropriate string in the "From" field of the SIP INVITE msg.This is independent of the "User ID" needed to register with the servic...
I have configured succesfully CIsco SPA112 - almost works, I just cannot change admin password. I log in with default user pass: admin/admin I go to adminsitration menu, but on the left nothing appears as in admin just link "quick setup" - and nothi...
Hello,I have a uc320w with 3 spa504g phones configured with a SIP trunk. My SIP provider is CallCentric. I have the phone system configured so that each phone is on it's own extension. For the most part the way I have it configured works except for t...
Hello.I'm from Paraguay and I need assistance with SPA8800 voip gateway.My problem is I don't recieve CIDI am sure that the PSTN line send the CID of the caller.The SPA is conected through SIP tunk to a asterisk server.This is the log of the SPAJan ...
We have 10 SPA509G phones. When we go into "Menu" - Directory - Local SpeedDial and then press the "EditDial" button, the phone reboots! It does that on the 4 phones I tried it on. Any idea what could be causing this?
Hello Everyone,I'm looking for some assistance with a BE3K that my colleague is deploying for one of our clients. The BE3K in question will not add any Cisco 6945's to it's database (saying "You must install more licences before you can add this phon...
I have remote offices connected to my data center with wireless links (ubiquiti radios in wds transparent mode and Tycon switches at solar powered sites). Remote offices can only be reached with a wireless link of several hops...I am installing VOIP ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: