Voice Systems and Accessories - Small Business

Hello,I wanted to ask if there are any possibilities to use the BLFs on the phones / extension board (e.g. SPA525G2 + SPA500S) to indicate the presence of a coworker.Currently all monitor-buttons are "off" in idle state and glow red if the montiored ...

Do we know if this has show back up in newer versions?  I have a UC540 running Software Pack 8.6.0 and VM 8.6.3 (CME 8.6) that this started happening to.  The device has been upgraded for two months now and it just started out of the blue. Able to re...

Hi, I have an SP that has a customer with a CM solution installaed, but they are requesting a UC320 for a reomte office, for now its standalone but in the future they plan to link both sites. Does the UC320 support networking with the CM? Thanks     ...

Hi fellows,I've a Cisco SPA502G that become stucked in "Initializing Network" and don't let me in in setup mode to make a Factory Reset.Anyone knows if there's a hard-reset to this phone pressing some button?Something like we do on 79XX, that connect...

I have a big problem about language dictionary and its download from network. I have to install several SPA504G in a bank with a SIP PABX. The bank doesn't give me access to the internet and to any PC in the LAN for security reason. What I can I do w...

More config fun.With all of our remote  locations, the outgoing callerid is a pretty big piece.  We have run  into another road block with the limit of 15 outgoing callerid rules 1  being the default and 14 custom.  With that in mind I am trying to c...

Hello, I tried to upgrade a UC560 using CCA and the latest Software Upgrade ("UC560-8.6.0.zip") & Locale Packs from cisco.com . While I've never expirienced any problems with UC540 the upgrade on my first UC560 fails.In the section where Voice Mail s...

I may be missing something really obvious but how can I setup dynamic membership in a BACD peer group using CCA? equivalent of "list 7100, 7101, 7102, *,*,*" and allow any other phone to do a dynamic login to the group using FAC *3group ? I've done i...

I have tried to find an answer to this all over the place and all I can find is that everything I have done is right but despite this the SPA3102 doesn't appear to be trying to make the SIP call at least from the syslog anyhow, perhaps I'm assuming t...

We have a UC320W on the latest firmware, randomly when a caller gets auto-attendant and presses the extension they want, they receive a busy signal. It's hapenning very randomly, and not every time. I have rebooted system, checked the firmware is on ...

Does anyone know if the SPA525G can show the caller ID of the person calling on a BLF line?Recently found that when using Polycom phones this information does show up ( via notify-XML from the Asterisk server ) whereas the Cisco SPA525G phones appear...

I have this goofy problem with a new uc320w installIts a simple setup, 6 phones, 3 pots lines (Verizon)Sometimes during outgoing calls, while the customer is dialing the phone just goes back to the main menu like they werent even dialingSometimes it ...

We are attempting to update phones for using the G722 codec.  However, when calls are placed with the "Use remote pref" set to yes, the remote caller will go up to HD whereas the callee stays at g711u.  The server is set for g711u, g729a, g722 for pr...