Voice Systems and Accessories - Small Business

We setup a Wireless Guest network to allow visitors access to the internet. Guests are assigned an IP address in a different subnet.Today it was discovered that guests had access to our LAN via the Guest wireless network. I am not sure what has chang...

I have two 'blast' groups, one for sales and the other for service. Each group has 3 members. The users phones show their personal extension and their blast group extension. The message indicator (blinking envelope) is not showing for the blast group...

We are using the built-in FTP option on Microsoft Server 2003 Standard Edition SP2. I have a UC540W-FXO-K9 unit with NAT rules to allow Port 20 and Port 21 traffic through to the IP of our server. Since NAT sets up ACL entries I also have under Rule ...

I just upgraded to the newest LD firmware and now my FXS port is not answering. I removed the user/phone and re-added it thinking that it may solve the issue, but that didnt work.I can directly dial its internal extension and my fax machine answers t...

I installed a uc320 customer is unable to dial certain exchanges like 611 for repair, numbers that begin with 647, 289,and ( 310 7 digit)

I've a SPA942 system. everything works well on this system, but this week, I call a conferance number, and the ask me to push the star button, to connect the conferance. But when I use the star, the call will direct ended.Can one off you tell me how ...

Hi,Can the Corporate Directory be updated by integrating with MS Exchange or LDAP?  I'm not sure where you can update the Corporate Directory in CCA?ThanksAshleigh

HiI have just upgraded our UC320 wto the latest firmware. The first thing that happened is that the email addresses for each user became "invalid email address" except for 1 which was a gmail address. The invalai addresses wer of the format user@comp...

anyone know what the 4 digit password is on a 504g phone to access network settings? for the the life of me I can't find it and remember it. I thought it was like 9696 but that didn't work.thanksjesse

Hi,i bought a new SG200-26P for replacing an unmanaged Netgear switch. Since that, one of my phones, the SPA941, is flashing the mute button very often. Phoning is possible, but it is annoying. I switched green ethernet for this port of and putted th...

Hi there,I have a customer that has multiple, separate accounts in it that all fall under the same company name.  In addition to this, they have individual schedules they are requesting for day/night mode.  Is it possible to do this?   Specifically I...

I need to reset a voicemail PIN on a Cisco 524s IP Phone.  It is connected to a UC520.  I can change the PIN in CME and reset it, but when I hit the voicemail button on the phone and put in the new PIN a voice says "Invalid entry".I'm wondering if I ...

HiI know that to integrate CUCM with SPA IP Phones is necessary to create a SIP profile, so far so good.The problem is how to configure SIP parameters on the SPA phone, someone can help me?best regards

Hi,the situation is now stable here, outbound calls are working properly, audio in both ways, ....However, on inbound calls I cannot hear the caller. I did not fill any nat parameters when I used the wizard to re-configurethe device.I attached the lo...