Hi, my customer have a UC520 with the following configuration. I want to know if it´s posible to assign multiple extensions to a single phone which as far as I know needs one (1) user license. For example, if I have 16 physical ip phones and assign 3...
Team,I have upgraded cca to 3.2 and a trying to configure the SSL vpn client on a UC540. One of the requirements of using full tunnel mode is the client must be installed on the router. CCA 3.2 gives an option to download it but the web page it sends...
On the UC500 voicemail system is there a way to stop the message that comes up after your personal greeting? The message is something like "Record your message at the tone. When you are finished hanu up or press * for more optoins."Thanks!
I have a client we deployed a UC560 system. Everythign was working but now the MWI lights stopped working. I have checked everything I can think of but I can not get them to light up. Any ideas would be helpful.I have attached a config. Below ...
Hello everybody and thank you,The context: Hotel. I have to reduce extension privilege so that the customers are not allowed to dial outside when checking out of a room.It has to be done through software automatically. I've been downloading tons of P...
I need some thoughts and or ideas. We deployed a new UC500 system for a client. They have 5 siteswith MPLS links between all. We are deploying phones in al location but only one call manager. The calls all work and route properly to the main l...
I have a UC560 installed on site which works great for all of our "normal" phones, however I am required to install a loud external ringer within a workshop at the other end of the site. There is only a fibre connection between the two buildings, no...
Hi there,one question. Is it possible to block some specific points at the phonemenu. E.g. configuration, network, user preferences, etc.The point is, that I only want to use the webfrontend to configure the phones...ThanksJoe
Recently, I had a call where the client had someone else setup the UC 520 and esw520 about a year ago. He requested the tech put the voice on the 10 network and the data on the 192. I noticed the esw520 is grabbing 192 ip's from the dhcp and not 10....
I post this against better judgement:The end of 2011 is near, and still no new firmware for the SPA3102.That will make it four (4) years of Cisco staff and management giving us customers the runaround. In laymans term: Cisco has lied to us for four y...
Can the SR520-T1 be used to connect to a frame relay network? Our carrier uses frame relay encap on its data T1 service.
I have a single UC540 at an office site in the northeast with a remote office in the midwest with a handfull of phones that register to the UC540 in the NE.Is there any way within the UC540 to have 911 calls from the NE phones routed to the local 911...
Hi members, I am not sure the limitation on the Small UC but I have an installation where the customer has 3 Separate business running out of the same box.They want a separate message for each business but have it ringing on the same members. I have ...
Do we need licenses when adding VG224s to the UC560 box. If yes, may you please help me with the kind of licensesthat we need. I have looked around the product data sheets and could not find anything.
Hi,can you help me to change language from English to Italian in a SPA502g?Thanks,Elia
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: